Gembird EG-PM2 Manual do Utilizador descarregar pdf (Página 32)

EG-PM2

PROGRAMMABLE POWER OUTLET STRIP

All brands and logos are registered trademarks of their respective owners

6. Troubleshooting

Problem

Solution

The rocker switch turns off.

The load connected to the device is too

high, some of the devices connected to

the EG-PM2-LAN should be disconnected

before the rocker switch can be turned on.

The switching command is not

carried out and indicators are

not lit.

There is no power supply to the EG-PM2.

Please, make sure the EG-PM2 is

connected to the power supply and the

rocker switch is switched on.

Software reports "Device I/O

request error" after switching

Check the grounding of EG-PM2. If

inductive load, like florescent lamps or

motors are connected to EG-PM2, it is

recommended to use an extra USB hub to

connect EG-PM2 to the managing

computer.

Timer schedule is delayed

Do not power EG-PM2 off when the

hardware timer schedule is active. Press

the Sync button for timer synchronization.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37

Sem comentários

Gembird EG-PM2 Manual do Utilizador Página 32