Gembird EG-PM2-LAN Manual do Utilizador descarregar pdf (Página 23)

EG-PM2-LAN PROGRAMMABLE POWER

OUTLET STRIP WITH LAN INTERFACE

All brands and logos are registered trademarks of their respective owners

Below the page you can see the current time of the web-server and

eventual information about the last successful timer synchronization.

Automatic timer synchronization is used if Use NTP for timer correction

option is enabled (see section 4.6 below).

NOTE: If a certain socket has a switching fault, e.g. it should be

switched on but the whole device is switched off, or it should be off but it

does have voltage, then the warning message Wrong voltage on socket!

will be shown above the Event schedule (see Figure #7 above). This

message might also indicate that this socket is defective.

For setting up the socket schedule click Set schedule button. You

will face then the page shown below (see Figure #8).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 64 65

Sem comentários

Gembird EG-PM2-LAN Manual do Utilizador Página 23